ZEOS Meridian 800 Manuel d'utilisateur télécharger pdf

Classroom AV Support Service - http://kb.mcgill.ca/it/classroom

Classroom Help Line - Press the Audiovisual Systems Help button on your classroom telephone Last updated: January 2015



LaptopExternalMonitorActivationChart

Some laptop computers de-activate their built-in monitors when a second display device (data projector) is

connected.

In order to activate/re-activate your laptop’s built-in monitor or external monitor port for projection, refer to the chart

below for instructions for your operating system:

Key commands for PC laptop models

Steps for Mac laptop models

For more information on setting up your laptop to display content on a data projector screen, refer to the following:

Setup instructions for PC

Setup instructions for Mac

Key commands for PC laptop models

Before you begin go to in the Classroom AV Instructions tool and check the Data Projector instructions for the

classroom. The basic instructions are as follows:

1. Make sure your laptop is turned off.

2. Ensure all AV cables (HDMI or VGA, Audio and Network) are connected to your laptop.

3. Press the LAPTOP button on the AV control panel. The data project may take a minute to warm up.

4. When the projector is running, turn on your laptop.

5. Decide whether to use Duplicate Mode or Extended Mode by following the key commands for your

operating system from the Lookup chart for PC models below.

Note: The laptop resolution must be set to match the display resolution of the data projector screen being used -

1024 x 768.

LookupchartforpopularPCmodels:

For Windows 7 and higher:

1. Press the Windows shortcut keys

2. On the box that appears

usethekeyboard’sleftorrightarrowkeysorthemousetomakea selection:

Select Duplicate

todisplaythesamecontent(mirror)onbothyourlaptopandthedataprojectorscreen.

1 2 3 4 5 6 7 8 9